The higher this number, the steeper the overhang has to be for supports to be generated. The default is 45 degrees, which is why all circular holes will end up with supports. This setting lets you choose how much of an overhang is necessary before Cura inserts supports. To tweak support placement, you can use the next setting. Here, supports will only start from the buildplate, so any overhang that is directly above the buildplate without any material below it will get a support.Įven if you select “Touching Buildplate”, you may find that Cura has unnecessarily inserted some supports. That’s why you will typically choose option 2: “Touching Buildplate”. Most of the time, you don’t need to be so aggressive with supports. So if you were printing a part that had a hole for a bolt on a vertical wall, the hole would get filled with a support structure. If you select “Everywhere”, any part of the model that has a slight overhang will get supports. Here, you have two options: “Everywhere” or “Touching Buildplate”. Under “Generate Support”, you’ll be able to choose where the supports will be located. You can tweak the settings to change how aggressive or conservative the supports are. Where will the supports go?Ĭura automatically generates support wherever it thinks supports should go. To start, go to Supports and click “Generate Support”. Now you should be able to see Support settings.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |